
Short answer: HXSCO supplies aluminum die castings in A380, ADC12, A356 and AlSi grades using cold-chamber high-pressure casting with tooling, machining and finishing – see our Die Casting Guide and the base material in our Aluminum Guide.
At a Glance

Our Aluminum Die Casting Range
We cast the common Al-Si-Cu and Al-Si-Mg grades for housings, covers, shells and structural parts; the grade logic is in our Alloys Guide and the base metal in our Aluminum Guide.
| Grade | Family | Typical use |
|---|---|---|
| A380 / ADC10 | Al-Si-Cu | General castings |
| ADC12 / A383 | Al-Si-Cu | 3C and auto shells |
| A356 | Al-Si-Mg | Wheels, structural |
| AlSi9Cu3 | Al-Si-Cu | Housings, covers |
Cold-Chamber Process
Aluminum is cast by the cold-chamber route because of its higher melting point; the cycle is detailed in our Cold-Chamber Guide and versus the hot chamber in our Hot-Chamber Guide.
Tooling and Wall Thickness
Thin-wall capability depends on gating and cooling; design rules are in our Mold Design Guide.
Finishing Options
Anodizing, powder coating and machining upgrade appearance and function; see our Finishing Guide and Surface Treatment Guide.
Quality and Certification
Properties and porosity are checked per our Quality Inspection Guide and documented per our Mill Test Certificate Guide; watch for issues in our Defects Guide.
Ordering and Lead Time
State grade, drawing, tolerance and volume; plan with our MOQ and Lead Time Guide.
Get a Quote
Tell HXSCO your requirements and we will respond with a competitive quote and lead time.
Frequently Asked Questions
ADC12 / A383 for general and 3C parts, A356 for structural and wheels.
Cold chamber, because aluminum melts at a higher temperature.
Yes – selected grades anodize well; ask about your grade.
Yes – machining and finishing are available.
Yes – foundry test certificates per lot.
Get an Aluminum Die Casting Quote
HXSCO supplies A380, ADC12, A356 and AlSi aluminum die castings with tooling, machining, finishing and certificates. Send your drawing and volume for a quote.
