Casting Defects Guide: Causes, Identification and Prevention

Casting Defects Guide: Causes, Identification and Prevention

Short answer: Common casting defects – gas porosity, shrinkage, cold shuts, sand inclusions and cracks – come from gating, melting or mould issues and are prevented process control and inspection, as covered in our Metal Casting Guide und Quality Inspection Guide.

At a Glance

Casting Defects Guide: Causes, Identification and Prevention chart
Figure 1 – Casting Defects Guide: Causes, Identification and Prevention overview.

Why Casting Defects Happen

Defects trace to melt chemistry, mould condition, gating and cooling; the process stages are in our Metal Casting Guide.

Porosity and Shrinkage

Gas porosity comes from trapped gas, shrinkage from poor feeding; both are found by sectioning and NDT; see our Quality Inspection Guide.

Cold Shuts and Misruns

Low pour temperature or slow filling freezes the metal before it joins; gating design and superheat are the fix, with the route in our Cast vs Forged Guide.

Inclusions and Surface Defects

Sand inclusions and scabs come from mould erosion; surface care is in our Surface Treatment Guide.

Cracks and Distortion

Residual stress and uneven cooling crack or warp castings; heat treatment can relieve stress per our Metal Heat Treatment Guide.

Inspection and Prevention

Layered inspection and documented process control prevent recurrence; third-party checks are in our Third-Party Inspection Guide and documents in our Mill Test Certificate Guide.

Get a Quote

Tell HXSCO your requirements and we will respond with a competitive quote and lead time.

Häufig gestellte Fragen

What is gas porosity?

Small gas holes trapped during solidification.

How do you prevent shrinkage?

Proper risers, chills and feeding.

What causes a cold shut?

Metal cooling before two streams fuse.

How are defects detected?

Visual, sectioning, X-ray and ultrasonic methods.

Do you inspect castings?

Yes – see our quality inspection guide.

Source Quality Castings

HXSCO supplies inspected castings with foundry and third-party certificates. Send your drawing and quality requirements for a quote.

Request a Quote

Dieser Eintrag wurde veröffentlicht am Blog. Setze ein Lesezeichen auf den permalink.