Casting Defects Guide: Causes, Identification and Prevention

Casting Defects Guide: Causes, Identification and Prevention

Short answer: Common casting defects – gas porosity, shrinkage, cold shuts, sand inclusions and cracks – come from gating, melting or mould issues and are prevented process control and inspection, as covered in our Metal Casting Guide dan Quality Inspection Guide.

At a Glance

Casting Defects Guide: Causes, Identification and Prevention chart
Figure 1 – Casting Defects Guide: Causes, Identification and Prevention overview.

Why Casting Defects Happen

Defects trace to melt chemistry, mould condition, gating and cooling; the process stages are in our Metal Casting Guide.

Porosity and Shrinkage

Gas porosity comes from trapped gas, shrinkage from poor feeding; both are found by sectioning and NDT; see our Quality Inspection Guide.

Cold Shuts and Misruns

Low pour temperature or slow filling freezes the metal before it joins; gating design and superheat are the fix, with the route in our Cast vs Forged Guide.

Inclusions and Surface Defects

Sand inclusions and scabs come from mould erosion; surface care is in our Surface Treatment Guide.

Cracks and Distortion

Residual stress and uneven cooling crack or warp castings; heat treatment can relieve stress per our Metal Heat Treatment Guide.

Inspection and Prevention

Layered inspection and documented process control prevent recurrence; third-party checks are in our Third-Party Inspection Guide and documents in our Mill Test Certificate Guide.

Get a Quote

Tell HXSCO your requirements and we will respond with a competitive quote and lead time.

Pertanyaan yang Sering Diajukan

What is gas porosity?

Small gas holes trapped during solidification.

How do you prevent shrinkage?

Proper risers, chills and feeding.

What causes a cold shut?

Metal cooling before two streams fuse.

How are defects detected?

Visual, sectioning, X-ray and ultrasonic methods.

Do you inspect castings?

Yes – see our quality inspection guide.

Source Quality Castings

HXSCO supplies inspected castings with foundry and third-party certificates. Send your drawing and quality requirements for a quote.

Request a Quote