
Short answer: Die casting alloys fall into four families – zinc Zamak and ZA for fine detail, aluminum A380 and ADC12 for light general parts, magnesium AZ91D for minimum weight, and copper alloys for strength and conductivity; compare in our Die Casting Guide.
At a Glance

Zinc Alloys: Zamak and ZA
Zinc offers excellent castability, fine surface and good strength for small precision parts; see our Zinc Guide and the Hot-Chamber Guide.
Aluminum Alloys: A380, ADC12, A356
Aluminum balances low weight, strength and corrosion resistance for automotive and 3C parts; see our Aluminum Guide e Aluminum Die Casting Supplier.
Magnesium Alloys: AZ91D and AM60
Magnesium is the lightest structural die-cast metal, useful where weight saving matters; the cold-chamber route is in our Cold-Chamber Guide.
Copper and Brass Alloys
Copper alloys give wear resistance, strength and conductivity for valves and fittings; see our Copper Guide.
How to Select an Alloy
Weigh strength, weight, castability, finishing and cost; the material selection method is in our Choose a Supplier Guide and the recycled content view in our Recycled Aluminum Guide.
Quality and Certification
Composition and properties are verified per our Inspection Guide and documented per our Mill Test Certificate Guide.
Get a Quote
Tell HXSCO your requirements and we will respond with a competitive quote and lead time.
Perguntas frequentes
Copper alloys are strongest; zinc ZA grades are also high.
Magnesium, then aluminum.
Zinc gives an excellent as-cast finish.
Zinc often is, for small high-volume parts.
Yes – see our die casting supplier page.
Get an Alloy Recommendation
HXSCO helps select the right die casting alloy and supplies castings with certificates. Send your part requirements for a recommendation and quote.
