Ductile Iron Guide: Nodular Graphite, Grades and Uses

Ductile Iron Guide: Nodular Graphite, Grades and Uses

Short answer: Ductile iron is cast iron treated so its graphite forms spheres rather than flakes, giving steel-like strength with good elongation; grades are set out in this guide and supply is on our Ductile Iron Supplier page.

At a Glance

Ductile Iron Guide: Nodular Graphite, Grades and Uses chart
Figure 1 – Ductile Iron Guide: Nodular Graphite, Grades and Uses overview.

How Nodular Graphite Forms

A magnesium treatment spheroidises the graphite, removing the stress-concentrating flakes of gray iron; the family context is in our Cast Iron Guide.

EN-GJS and ASTM A536 Grades

Grades pair tensile strength with elongation: higher strength means lower ductility; specification method is in our Choose a Supplier Guide.

Ductile vs Gray Iron

Ductile wins on impact and strength, gray on damping and cost; see our Gray Iron Guide.

Heat Treatment and ADI

Austempering yields austempered ductile iron with high strength and toughness; see our ADI Guide ve Metal Heat Treatment Guide.

Where Ductile Iron Is Used

Water pipe, fittings, gears, crankshafts and wind hubs; the infrastructure view is in our Construction Guide and the casting basis in our Metal Casting Guide.

Quality and Certification

Nodularity counts and mechanical tests are documented per our Quality Inspection Guide; watch for defects in our Casting Defects Guide.

Get a Quote

Tell HXSCO your requirements and we will respond with a competitive quote and lead time.

Sıkça Sorulan Sorular

What does SG iron mean?

Spheroidal graphite iron, same as ductile iron.

EN-GJS-500-7 meaning?

500 MPa tensile, 7 percent elongation.

Can ductile replace steel?

Often, where castability and cost matter.

Which grade for pipe?

EN-GJS-500-7 is widely used.

Do you supply ductile iron?

Yes – see our ductile iron supplier page.

Get a Ductile Iron Quote

HXSCO supplies EN-GJS and ASTM A536 ductile iron pipe, fittings and castings with foundry certificates. Send your drawing for a quote.

Request a Quote