Short answer: Wear plate and hardfacing protect mining, cement and earthmoving parts from abrasion and impact using chromium-carbide overlay on a quench-and-tempered base, with ceramic-embedded and hardfaced options chosen by the wear mode and rebuild need.
At a Glance
Overlay Chemistry
Chromium-carbide overlay on a base plate gives a hard, abrasion-resistant surface, with hardness detail in our Hardness Comparison and heat treatment in our Heat Treatment Guide; the mining fit is in our Mining Equipment Guide.
Base Plate and Support
The quench-and-tempered base carries load and impact, graded like the structural basis in our Comparaison des forces and the oil and gas view in our Oil and Gas Guide.
Repair and Rebuild
Hardfacing wire rebuilds worn parts by welding, detailed in our Welding Joining Guide et Machining Guide; surface prep is in our Surface Treatment Guide.
Specifying and Sourcing
Buyers set wear mode, thickness and impact, then confirm with our Quality Inspection Guide and pack per our Export Packing Guide.
Get a Quote
Tell HXSCO your requirements and we will respond with a competitive quote and lead time.
Questions fréquemment posées
A base steel plate with a hard overlay that resists abrasion and impact.
For high impact plus sliding wear where overlay alone would crack.
Yes – hardfacing wire rebuilds them by welding for a second life.
Quench-and-tempered steel that carries load and absorbs impact.
By the wear mode – higher carbide for sliding abrasion, toughness for impact.
Protect Equipment with HXSCO Wear Plate
HXSCO supplies chromium-carbide wear plate, ceramic-embedded plate and hardfacing wire for mining, cement and earthmoving duty. Send your wear mode and size for a quote.