Structural Steel Supplier – H-Beams, I-Beams, Columns, Channels and Angles

Structural Steel Supplier – H-Beams, I-Beams, Columns, Channels and Angles

Short answer: HXSCO supplies hot-rolled structural steel sections – H-beams, I-beams, HEA and HEB columns, channels and equal angles – in S235, S275 and S355 for frames, buildings and infrastructure, backed by the stock-form basis in our Steel Beam Buyers Guide and the material basis in our Carbon Steel Supplier page.

At a Glance

Structural Steel Supplier – H-Beams, I-Beams, Columns, Channels and Angles chart
Figure 1 – Structural Steel Supplier – H-Beams, I-Beams, Columns, Channels and Angles overview.

Our Structural Steel Range

We stock and cut the full family of hot-rolled structural sections for building frames, mezzanines, canopies and plant structures. The material basis is in our Carbon Steel Supplier and the parallel stock-form detail in our Steel Section Guide.

Section Typical grade Primary use
H / I Beam S355 / A36 Beams, frames
Column HEA / HEB S355JR Vertical load
Channel U / C S275 / A36 Brackets, rails
Angle L equal S275 / A36 Bracing, trim

Forms and Processing

Sections are supplied as mill length, cut to length, and with simple fabrication – holes, cope cuts and weld preps – under the route described in our Metal Welding Guide. Surface care is in our Metal Surface Treatment Guide.

용접 및 제작

Structural grades weld with low-hydrogen electrodes and qualified procedures; connection design follows the section properties in our Steel Column Guide and the fabrication notes in our Structural Steel Buyers Guide.

Quality and Certification

Each lot ships with an EN 10204 type 3.1 certificate and, where required, CE marking backup, verified by the method in our Quality Inspection Guide and the document detail in our Mill Test Certificate Guide.

Ordering and Lead Time

State section, grade, dimensions and quantity; plan timing with our MOQ and Lead Time Guide and price with our Price Quotation Guide. Weight estimates use our Steel Weight Calculator.

Get a Quote

Tell HXSCO your requirements and we will respond with a competitive quote and lead time.

자주 묻는 질문

Which grade should I use?

S275 for general frames, S355 where higher strength reduces weight.

Can you cut and drill sections?

Yes – cut to length with holes and cope cuts on request.

Do you certify the steel?

Yes – EN 10204 type 3.1 with each lot.

Do you supply columns and channels?

Yes – HEA/HEB columns and U/C channels from stock.

Do you export?

Yes – bundled, marked and documented for export.

Source Structural Steel with HXSCO

HXSCO supplies H-beams, I-beams, columns, channels and angles in S235 to S355 with mill certificates and cut-to-length service. Send your section schedule for a quote.

Request a Quote

이 항목은 Blog에 게시되었습니다. 퍼머링크를 북마크에 추가하세요.